Recovery System im EIBPORT

From the date of manufacture January 2021 the EIBPORT will be delivered with a Recovery System.

The device is visually marked with a black point, which is located between the KNX programming button and the programming LED.

If the EIBPORT shouldn’t be found longer e.g., in the BAB STARTER, the EIBPORT can be restored to the delivery state with the help of the recovery system.

The EIBPORT can only be switched to recovery mode during the boot (start) phase. To do this, the KNX programming button (bottom right) must be held down while the operating voltage is applied. This applies to all EIBPORT variants. The programming button must remain pressed until the red programming LED lights up.

From this moment the EIBPORT starts the recovery mode. Now the programming button can be released.

During this process never the device must be de-energized.

The recovery takes about 15 minutes. During this time the progress is displayed using the four device LEDs on the front of the EIBPORT. It starts with just one (the upper) flashing LED. Then it continues successively with more and more flashing LEDs. If all LEDs stop flashing and go out, the EIBPORT restarts after the recovery.

The EIBPORT is now reset to the factory settings and the IP addresses and network parameters from the manual apply again.