The DUODMX GATEWAY is designed as a DIN rail (REG) device and can be installed close to the DMX lighting system.
Requirements
The following components are required for operation:
-
Power supply (12–32 V DC)
-
Network connection (not mandatory, but recommended for configuration and the preview function)
-
Connection to the DMX bus
-
Connection to one of the following control systems:
-
Network
-
KNX
-
-
DMX Configurator software
Configuration
The device is configured using the DMX Configurator software, either via the network or using an SD card.
-
For configuration over the local network, the PC must be in the same IP subnet as the DUODMXGATEWAY.
-
If network configuration is not possible, the project data can alternatively be transferred using an SD card.
-
NTFS-formatted SD cards are not supported. Use an SD card formatted with the FAT file system.
-
If the DUODMX GATEWAY cannot be found during the device search, disable all network interfaces except the one currently in use.
-
Always ensure the correct polarity when connecting the power supply.
-
For configuration via SD card, you will need a standard FAT-formatted SD card and an SD card reader connected to your PC.
Contents
///