In this section, you configure the KNX group addresses used to control playback and receive playback status information.
Play/Pause (EIS 1)
Enter the group address used to control playback.
|
Value |
Function |
|---|---|
|
0 |
Pause playback |
|
1 |
Start playback |
Depending on the connected system, these values may need to be inverted.
Play/Pause – Status (EIS 1)
Enter the group address from which the current playback status is reported.
|
Value |
Status |
|
0 |
No active playback, for example Pause or Stop |
|
1 |
Playback active |
If Invert Play/Pause is enabled, the reported status values are also inverted.
Invert Play/Pause
Enable this option to swap the values used for Play and Pause. This may be required depending on the connected system, for example when using BAB Alexa.
|
Value |
Function (Inverted) |
|
0 |
Start playback |
|
1 |
Pause playback |
The inversion applies to both playback control and status feedback.
Stop (EIS 1)
Enter the group address used to stop playback.
Any received EIS 1 telegram triggers the stop command, regardless of whether the transmitted value is 0 or 1.
Recommendation
Use the value 1 as the stop command for consistent operation.
Stop – Status (EIS 1)
Enter the group address from which the current stop status is reported.
|
Value |
Status |
|
0 |
Playback active |
|
1 |
Playback stopped |
Previous/Next Track (EIS 1)
Enter the group address used for track navigation.
|
Value |
Function |
|
0 |
Restart the current track or skip to the previous track |
|
1 |
Skip to the next track |
If the current track has been playing for more than 4 seconds, sending 0 restarts the current track. If playback has been active for 4 seconds or less, the previous track is selected.
Note
Track navigation is not supported by every audio source.
Shuffle (EIS 1)
Enter the group address used to control shuffle playback.
|
Value |
Function |
|
0 |
Disable shuffle |
|
1 |
Enable shuffle |
Shuffle – Status (EIS 1)
Enter the group address from which the current shuffle status is reported.
|
Value |
Status |
|
0 |
Shuffle disabled |
|
1 |
Shuffle enabled |
Repeat (EIS 14 / 0–255)
Enter the group address used to control the repeat function.
|
Value |
Function |
|
0 |
Repeat playlist |
|
1 |
Repeat current track |
|
2 |
Repeat off |
Any other values are ignored by the Smart Home App.
Repeat – Status (EIS 14 / 0–255)
Enter the group address from which the current repeat status is reported.
|
Value |
Status |
|
0 |
Playlist repeat enabled |
|
1 |
Current track repeat enabled |
|
2 |
Repeat disabled |
///