Settings and Connecting to Apple® Home

The Homelink Smart Home App integrates Apple Siri® into your Smart Home based on KNX, EnOcean, and Easywave.

The BAB Homelink Smart Home App for the APPMODULE provides the interface to the Apple Home app.

A maximum of 150 devices can be integrated into Apple Home through a Homelink bridge. This limitation is defined by Apple®.

Connecting the APPMODULE to Apple Home

To connect your BAB APPMODULE to Apple Home, proceed as follows:

Step 1

Assign an instance name.

Step 2

If the APPMODULE has already been paired with Apple Home, first remove the existing pairing from the Apple Homeapp.

Step 3

• Click "Start Pairing".

• Wait approximately 3 seconds.

• Open the Apple Home app.

• Select "Add Accessory".

• Choose "More Options..." and then "My Accessory Isn't Shown Here", or select "Enter Code Manually", depending on your Apple Home version.

• Enter the pairing code displayed in the instance.

The pairing process is now complete.

Step 4

Now create the desired devices:

1. Click "Add".

2. Select the required device type (for example, Switch).

3. Configure the corresponding group address.

4. Click "OK".

5. Select "Save and Close".

After a short time, the newly created device should appear in the Apple Home app.

The connection between your BAB APPMODULE and Apple Home is now established. Voice commands issued through Siri® are forwarded to the APPMODULE and used to control your Smart Home devices.

///