In this section, you configure the transmission of the current date to the KNX bus.
The date can be transmitted automatically at a freely selectable interval or manually via a trigger telegram.
Date (EIS 4)
Enter the group address to which the current date should be transmitted.
The date is transmitted automatically:
-
when the instance starts,
-
after a trigger, or
-
according to the configured transmission interval.
Trigger (EIS 1)
When the value 1 is sent to this group address, the current date is immediately transmitted to the configured group address.
Transmission Interval (Hours) (0–12)
Specify the interval at which the current date should be transmitted automatically.
Permitted values:
-
0 = The date is transmitted only when it changes (at midnight) or after a trigger.
-
1–12 = The date is additionally transmitted at the configured hourly interval.
The default value is 12 hours.
///